New P4/RBX Water Cooling Rig...

[mamisano]

New P4/RBX Water Cooling Rig [Pics]

Just finished seting up my Watercooling on my recently aquired P4 2.6C/Abit IC7 combo. Here are my components:

-Single Pass HC
-Single 120mm Fan, Tupperware shroud
-DangerDen RBX, Plate #1
-Via Aqua 1300
-Clearflex-60 1/2 tubing
-T-Line, no res

I had to hack up my case pretty good to get the rad to fit. See Before:

and After:

With Front off:

Side View:

 

[mamisano]

Rear (Notice ArcticCool )

So All in All, I added Water Cooling, lapped the stock NB HS/F while adding AS 5, and installed an Arctic Cool on my Radeon 9800.

Temps Before, running stock HSF/Voltage/Speed was 59-60c at load (Prime AND Folding both running)

Now, with 1.625v (1.6 measured), WC, 3250Mhz I am at 50c at full load.

I know the Abit boards tend to read high, am I safe with these temps?

I want to push more, but that will happen later on

 

[mamisano]

Hmmm....no comments??

 

[nikhsub1]

Temps seem a bit warm. What is ambient? Your tubing looks as if it is exerting a good amount of 'pull' on the block. You should rectify that ASAP.

 

[mamisano]

Tubes are fine, no pull on the block. I have also since zip-tied the pump down

 

[cherryp00t]

if you're in ny temps should be quite low this time of the year with the big snow and all.. unless your house is heated up to summer temps i dont see why your temps are so high

 

[Deathmasher]

well I have to say that the install looks pretty good