• Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!

Problems with geil ultra x and epox 9nda3

Overclockers is supported by our readers. When you click a link to make a purchase, we may earn a commission. Learn More.

k_laurent02

Registered
Joined
Dec 23, 2005
I have just received this epox board along with a 3700+, and i decided to use my old set of geil ultra x memory for this system. The installation went fine and it posted successfully, but after installing windows and running for an hour or so i would get a blue screen. So im like ok lets reset real quick and see whats wrong, but after getting this blue screen i can't get back in windows. It is as if that error wiped windows of my hard drive. So i decide to reinstall windows and the pc runs fine through the installation. And again after getting windows to work and while trying to install drivers i get a blue screen again and same thing, windows is wiped and i cant get back in it. I get the error " the system cannot log you on because the domain Username is not available".
i used every part except the new epox board and amd processor in a previous p4 system. the ram was great for p4 with a asus p4c800 edeluxe.
Does anyone have any idea why this new setup isnt working?

specs:
Epox 9nda3
Amd 3700
zalman 7700
2 x 512mb Geil Ultra X 2-2-2
Hitachi t7k250 sata2
Antec true power 430W
audigy 2
everything running stock in bios
 
k_laurent02 said:
I have just received this epox board along with a 3700+, and i decided to use my old set of geil ultra x memory for this system. The installation went fine and it posted successfully, but after installing windows and running for an hour or so i would get a blue screen. So im like ok lets reset real quick and see whats wrong, but after getting this blue screen i can't get back in windows. It is as if that error wiped windows of my hard drive. So i decide to reinstall windows and the pc runs fine through the installation. And again after getting windows to work and while trying to install drivers i get a blue screen again and same thing, windows is wiped and i cant get back in it. I get the error " the system cannot log you on because the domain Username is not available".
i used every part except the new epox board and amd processor in a previous p4 system. the ram was great for p4 with a asus p4c800 edeluxe.
Does anyone have any idea why this new setup isnt working?

specs:
Epox 9nda3
Amd 3700
zalman 7700
2 x 512mb Geil Ultra X 2-2-2
Hitachi t7k250 sata2
Antec true power 430W
audigy 2
everything running stock in bios


Try increasing the dimm voltage by .1 volt.
 
Back