• Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!

Removing Ramsinks?

Overclockers is supported by our readers. When you click a link to make a purchase, we may earn a commission. Learn More.

cypher_138

Member
Joined
Mar 23, 2003
Location
NJ
I epoxied ramsinks onto my 9800XT with Artic alumina epoxy with a little AS5. Whats the best way to remove them without damaging the card?
 
OP
cypher_138

cypher_138

Member
Joined
Mar 23, 2003
Location
NJ
Never mind. I found that I've been getting a kink behind the fan when I put my panel on @ the GPU WB. I'll have to use a 90 to remedy it. I also figure the warranty is voided on this card as is so I pulled the shim off of it. I didn't think heat would cause the problem I was having.
 
OP
cypher_138

cypher_138

Member
Joined
Mar 23, 2003
Location
NJ
Hey Tawcan.:D I've seen a few post from you here and at EOC as well. You got to love a post where you answer your question before you get a response. I should have held off.;)
 

Tawcan

Registered
Joined
Dec 17, 2002
Location
Vancouver, BC
cypher_138 said:
Hey Tawcan.:D I've seen a few post from you here and at EOC as well. You got to love a post where you answer your question before you get a response. I should have held off.;)

Hehe~ :D Just browsing around...no more stay on one specific forum for me. ;)