SE6 voltage

[MisterQ]

hey does anyone know how I can get higher votages b/c my celery 600 can run 900 on my other board where i had a slocket card and had it at 1.85v and I am limited to 1.7v max on the SE6

 

[outhouse]

There may be a BIOS flashing trick for your MB that may help if not Vidpinning may also work

 

[anvil]

If you do a search back several months for "abit bios reflash" there are some descriptions of the reflash trick for the bh6 board I believe. I did find one of these that worked on my bx6 R2, so you might get lucky too. (I seem to recall that there was a short command line extension to be used when reflashing the bios and a longer one. The short did not work for me, but the longer one did.)

anvil

 

[marty]

The BIOS reflashing trick is not known to work on the SE6. So you are faced with doing the pin trick on the CPU. That is what I had to do to get my SE6 to allow voltage high enough to reach 933 with my PIII 700 cB0.

 

[batboy]

I wired the VID pins on my CPU when I was using a SE6 also.