• Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!

SoftFSB and an EPoX EP-58MVP3C-M won't work

Overclockers is supported by our readers. When you click a link to make a purchase, we may earn a commission. Learn More.


New Member
Mar 11, 2001
I'm trying to set my FSB higher than my jumpers will allow using FSB. The board is supposed to allow over 100MHz, but SoftFSB doesn't recognize the PLL-IC chip. I can get it to recognize somewhat, but it doesn't allow any bus speed higher than 100MHz. My manual says I should be able to go to112, so I'm wondering if there's anything I can do? My clock generator is a Winbond W83194R-37. Thanks!