Switching black grounds on psu molex?

[Enihcam]

I'm going to be sleeving my psu cables and I was wondering if anything would happen if the black ground wires were switched on the molex. Would it stuff my psu? Thanks.

 

[Enihcam]

hello? anyone home?

 

[Cjwinnit]

It shouldn't, but you might find it an unecessary risk. Just so you know, all the black DC ground wires coming into a PSU almost always meet at one solder point.

Why do you feel you need to do it?

 

[bubba gump]

I don't think he necesarily wants to do it....it would probably be just in case he accidentally switched them around during the rewiring of the molexes...but a good way to make sure you get all wires back where they need to be (very helpful for the 20-pin atx connector) is to put some tape around it, and make a mark or 2 or something so you can tell which designated wire goes back into its right spot.

Get what I mean?

Fold and Frag on
Brian