TC-4 and maze thickness

[DeathONator]

I am going to buy either the TC-4 mounting hardware, or the Maze hardware for my almost done waterblock. My block is on the thick side so I want to make sure the springs are short enough, or the rods are long enough for me to get the screws on w/ out too much struggling.

So anyways if you know the thickness of the TC-4 or Maze2 please post.

Thanks...

Oh and if you have the time and knowledge, it would be great if I knew the legth of the rods and uncompressed springs for each mounting kit.

 

[Chief_Wiggum]

Well, I tried to get my calipers into my case, but no go

But with the plastic ruler looks like my TC4 is 22mm high.

The bolts included with the kit extend 60mm high from the top of the mb, so they're actually a little longer. Screwed all the way down there's about 8mm of thread left.

That's the best I can do for you without removing the block.

 

[JFettig]

Im sure the block is .75" thick, and the bolts are 2.5" not 100% sure though.


Jon

 

[DeathONator]

Thanks alot guys! You are now my new heros for the week!