Those with BH-5 please post your Volts/Timing/Max FSB

[Banyan]

title says it all. just curious what people are hitting, and particularly the voltage. thanks goes out to all who post...

 

[Surfeit00]

mushkin level II pc3500

they cant do ddr430 at 2-2-2-5 timings with an 2.85 vdimm, sort of disappointing...

 

[squads]

check sig...using 11 cause its best for nf7-s. it only does 214 2-2-2-11 but when i go 2-2-3-11 it does 225, i havent tried any higher.

 

[squads]

mushkin level II pc3500

they cant do ddr430 at 2-2-2-5 timings with an 2.85 vdimm, sort of disappointing...

i thought level II black was required to do 2-2-2 @217 otherwise you can get replacement sticks.

 

[dryars]

Kingston HyperX PC3200 A01:

@2.9v
Max FSB - 224
Max Memtest - 222

 

[wannaoc]

Buffalo 3700 @ 2,2,2,6 with 2.9V(BIOS setting: 3.0V MBM5)

I have sitting in my greedy little hands some Mushkin 3500 to replace this and if I remember right that 2.8V or so.

 

[tyson-chris]

2x256mb Mushkin Black Level 2 PC3200 - in Dual Channel, CPU Inteface Enabled.

200@2-2-2-11, 2.65v (2.6v BIOS - I'm sure it could do it at 2.5v, but for some inexplicable reason, my board has 2.6v as the lowest vdimm setting...)
217@2-2-2-11, 2.75v (2.7v BIOS)
233@2-2-2-11, 2.98v (2.9v BIOS)
235@2-2-2-11, 2.98v (2.9v BIOS)

all memtest stable, except for 235. It starts to error after about an hour in memtest. I'm not sure if it's necessarily the memory or the chipset (mem controller part) that's crapping out. I can't test with dividers to find mem max because the dividers are totally screwed on my board, and result in no post, no matter what divider I use.

 

[Banyan]

can't get mine past 217 with my chip

 

[CamH]

Mushkin Black Level II PC3200

227MHz, 2 2 2 5

 

[sp00L]

Check the sig. After I burn these in I'm aiming for 2.9-3.0 vdimm instead of the 3.1vdimm. My Mushkie's did 2-3-2-6 @ 225 but one poop out and is in rma....