Hey all,
I'd been running a Celery 566 at 850 for about 18 months, but I decided to flash my BIOS up to SS and plug in a 700. It's running OK at 1050, but not stable enough to complete a 3D Mark 2K1 benchmark. I had a similar problem with the 566/850, but I cranked it up to 2.0 V and it was fine; unfortunately, my BIOS flash seems to have reset the voltage range and I can't set it any higher than 1.90. I know there was a trick to doing this, but I can't figure it out. I've got a BH6 1.0 and an ABIT Slotket II. I tried manually setting the voltage on the slotket's jumpers and re-flashing my BIOS (to SS again), but nothing changed. Anybody know the work-around? Thanks.
I'd been running a Celery 566 at 850 for about 18 months, but I decided to flash my BIOS up to SS and plug in a 700. It's running OK at 1050, but not stable enough to complete a 3D Mark 2K1 benchmark. I had a similar problem with the 566/850, but I cranked it up to 2.0 V and it was fine; unfortunately, my BIOS flash seems to have reset the voltage range and I can't set it any higher than 1.90. I know there was a trick to doing this, but I can't figure it out. I've got a BH6 1.0 and an ABIT Slotket II. I tried manually setting the voltage on the slotket's jumpers and re-flashing my BIOS (to SS again), but nothing changed. Anybody know the work-around? Thanks.
