Hi, i read your article on the danger den water block vs a open water block design. I have just finished making my own home design, machinist milled water block. Im using a 230gph water pump @ 0 head preasure through 1/2″ Inner Diameter hoses. The water runs into the bottom and out the top inlets. I am using a giant Aluminum pot with about 3 gallons of distilled water at room temperture, 79 degrees F, as my water resevour. I need to add a radiator, cause the water temp in the resvour gets high quickly. On my 1700 XP, at the default voltage, at idle, my mobo reads a 36 C temp. With my old Coolermaster HSFand 3 case fans, it was about 44 C.
For The Bleeding Edge Only This board is for those who want to go where no man has gone before, and aren’t too concerned about the cost. Outside of a memory tweak which Canterwoods have and Springdales don’t, the real Read More
The CoolerMaster Storm Gaming Case merits some serious consideration if you’re building an ultimate system.