Chaintech Zenith...oc problems

Hey whats up...i was running an epox 8k3ae at 2.43 187x13 and i decided to get a Chaintech Zenith...the thing basically wont run any oc besides default.....i did 6x200, and also put my memory to 66% to rule out memory problem, and it didnt post.....i have an xp2100 tbred (b) wtf is goin on...

Hmmm ... you better check with Chaintech support, I never heard about this problem from any of my customers. But again, I am not too familiar with Chaintech.

But as long as it runs stable on default, it shouldn't be much of a problem, right? annoying tho