- Joined
- Oct 19, 2001
- Location
- Greensboro, NC
I just made a few of these, they fit a Chevette heater core, 6x6 inches. Just testin the water here to see if there is any interest in them. I was thinkin about takin a few orders for em if there is enough interest in them. I dont wanna get in major production but I picked up a large sheet of copper at a good price and hate to waste it. Havent decided on a price but it wouldnt be over expensive, thinkin bout 2 prices, one for polished and one unpolished. I got the process down pretty well and can whip em out in about an hour or less. This one hasnt had hole cut yet but you get the general idea, I will put up another pic later. Or, if ya wanna make your own I will show ya how, its pretty simple. What ya think?
http://prod.bsis.bellsouth.net/coDataImages/p/Groups/86/86294/folders/74034/597902shroud.jpg
I deleted that pic, look on down and there are some more pics.
http://prod.bsis.bellsouth.net/coDataImages/p/Groups/86/86294/folders/74034/597902shroud.jpg
I deleted that pic, look on down and there are some more pics.
Last edited: