- Joined
- Oct 16, 2003
- Location
- 5min from Philly Airport
can someone tell me if I'm doing this right?
I tried my to mount my cpu wb and I thought I had it clamped
well. I started the pc and it shut down after about 10 sec. I checked and re-seated the wb and tried to boot again. this time it shut down after 5 sec.
My diy clamping system may be at fault.
How much pressure is needed for the cpu wb? I see a lot
of hold down systems with springs. What is the spring rate needed?
I went back to my Vantec copper flower, reset my cmos and it booted right up.
Please help as I'd like to get my cooling rig set.
VBallCoach
I tried my to mount my cpu wb and I thought I had it clamped
well. I started the pc and it shut down after about 10 sec. I checked and re-seated the wb and tried to boot again. this time it shut down after 5 sec.
My diy clamping system may be at fault.
How much pressure is needed for the cpu wb? I see a lot
of hold down systems with springs. What is the spring rate needed?
I went back to my Vantec copper flower, reset my cmos and it booted right up.
Please help as I'd like to get my cooling rig set.
VBallCoach