Hey all, I'm new to the forum (at least I've finally started posting).
I'm planning on designing & building a case from scratch, and I'm putting together the part list and 3D models at this stage. For the watercooling system, I have already aquired an Iwaki WMD20RLZT and a 73' Caprice hc. The hc will be in its own air flow zone, drawing air through a grill on one side of the case, and blowing it through the hc and out a grill on the other side (I'll start another thread with progress + renders if you guys want for the case). However, I want to use a Torin blower for the heatercore, but I want to keep it inside the case. Will the blower's performance be hampered if it is in a wind tunnel type duct, with a large grill at one end of the wind tunnel?
Also, if a blower will work ok without sucking air in an enclosed space, what blower would you guys recommend for a Caprice hc? I have attached dimensions and a render I made of the hc for those of you that don't have them off hand.
I'm planning on designing & building a case from scratch, and I'm putting together the part list and 3D models at this stage. For the watercooling system, I have already aquired an Iwaki WMD20RLZT and a 73' Caprice hc. The hc will be in its own air flow zone, drawing air through a grill on one side of the case, and blowing it through the hc and out a grill on the other side (I'll start another thread with progress + renders if you guys want for the case). However, I want to use a Torin blower for the heatercore, but I want to keep it inside the case. Will the blower's performance be hampered if it is in a wind tunnel type duct, with a large grill at one end of the wind tunnel?
Also, if a blower will work ok without sucking air in an enclosed space, what blower would you guys recommend for a Caprice hc? I have attached dimensions and a render I made of the hc for those of you that don't have them off hand.
Last edited: