- Joined
- Oct 2, 2001
- Location
- Corona, CA
Question about a crazy setup
Well I was gonna build to 2 seprate rigs both W/Ced. Now its down to one. I have 1 Un-known dual 120mm cheve core and 2 JR-120's. would it make sense to make a loop like this? Here are my componets.
Swifty 6000 block
Beckett 320GPH Pump 12.2FT max head (dumpes 50watts into the water)
Dual 120mm HC on top outside my case, holes cut for fans and tubbing
VGA waterblock, undecided right not
2 JR120 heater cores in the front of my chieftec case on their sides.
My loop would go: Pump(pump will be in the rez, custom desgin) >> dual 120 HC>>cpu>>to top JR-120>>vga block>>2 JR-120>>rez. Would that be to much for this pump, and would I get close to the same temp if I just did either the dual HC or both JR-120's. The reason I ask is B/C I might as well use if I can mabey knock off 3-4C.
Well I was gonna build to 2 seprate rigs both W/Ced. Now its down to one. I have 1 Un-known dual 120mm cheve core and 2 JR-120's. would it make sense to make a loop like this? Here are my componets.
Swifty 6000 block
Beckett 320GPH Pump 12.2FT max head (dumpes 50watts into the water)
Dual 120mm HC on top outside my case, holes cut for fans and tubbing
VGA waterblock, undecided right not
2 JR120 heater cores in the front of my chieftec case on their sides.
My loop would go: Pump(pump will be in the rez, custom desgin) >> dual 120 HC>>cpu>>to top JR-120>>vga block>>2 JR-120>>rez. Would that be to much for this pump, and would I get close to the same temp if I just did either the dual HC or both JR-120's. The reason I ask is B/C I might as well use if I can mabey knock off 3-4C.
Last edited: