Instable i believe need advice

My comp just rebooted a few mins ago. it wasn't the temp cause it was like 105 f

and i was just browsing the net too

my voltage is default with 2600mhz i guess its about time to raise this bad boy

my question is right now its 1.4 volts

i guess 1.445 or 1.460 would be good

can anyone give me the % to make it those

like 1.3 +10%?

anything like that would help. thnx

give me a few examples plz

anybody?

The advice I see more than any other on these boards about voltage is "the absolute minimum required to achieve stability"

I would go into your bios and see how the voltage is currently set, then make the smallest increase your system will allow. Then run your system that way unless that also proves to be unstable. Then just keep bumping up the voltage in the smallest increments you can until you achieve stability.

I would, however, recommend you hunt through the CPU and motherboard forums to check what the maximum 'safe' voltage for your setup would be. If you reach that and still aren't stable, then, unfortunatly, it becomes time to crank back the clocks.

DWolf

that vcore is pretty low- I'd raise it a notch at a time until you are stable.

My mobile 2600 needs 1.65 volts for 2.5 ghz.