- Joined
- Mar 19, 2004
...is it really worth it?(temps and noise wise) or should i just get one 120 sanyo denki?
Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!
bapski said:you may want to try a pull >> pull setup . tried it and had significant decrease in LOAD TEMP.
bapski said:you may want to try a pull >> pull setup . tried it and had significant decrease in LOAD TEMP.
Agree. But using a shroud and fans in a pull configuration evens out the pressure (vacuum!) across the face of the rad. For most this ia a goodthing. Even with shrouds, a push configuration results in uneven pressure across the face of the rad. Less in the center, more under the blades and less at the perifery. But overall, either way shows very small differences.meionm said:the difference between push and pull is minimal on any radiator.
shawkins said:So if Im using a BIXIII, should I do push or pull? I dont have room for push and pull.
Im hoping pull, because I was thinking about mounting the RAD on top of my case.
Thanks
It won't really matter that much. What ever works better for you.shawkins said:So if Im using a BIXIII, should I do push or pull? I dont have room for push and pull.
Im hoping pull, because I was thinking about mounting the RAD on top of my case.
Thanks
meionm said:Depending on the radiator Thermochill PA series does better with push. Though the difference between push and pull is minimal on any radiator.
wonder where you got this data. can't seem to find any article, thread that would support this.
all i found is this: THERMOCHILL.COM and there is no mention of pa series benefiting a push config.
I thought the purpose of Push Pull is so that u can run both fans at like 7v or lower settings to get the same performane as 1xfan @ 12v....or using 2x slower thans instead of 1 faster......get it?
=LESS NOISE...this may just be a theory since it's just what I've been told
[O-CuK]Marci said:S'been said by myself and Cathar in various threads around the net on various forums... mainly on XS. Testing results aren't yet complete for PA Series hence not published yet.
See http://www.xtremesystems.org/forums/showpost.php?p=1081012&postcount=86
http://www.xtremesystems.org/forums/showpost.php?p=1081519&postcount=97
S'also in the ThermoChill FAQ, under section 3.