Well, the 8800gtx won't fit so it's time for a new case. Since I have to redo my WC I figured I'd go with 1/2" tubing this time (from 3/8"). I was thinking about 1/2 ID X 3/4 OD MasterKleer (#5233K68). I was going to do the 8800 too (just doing cpu now) so should I go with a mcr320 instead of my mcr220? I'm using a mcp350 now. I was going to get the petra top so I can use 1/2" barbs with 1/2" tubing. If I go with the mcr320 and the additional block for the 8800, would it be better to get the mcp355? Does all this sound ok?
tubing: (3/8 ID X 5/8 OD) to (1/2 ID X 3/4 OD)
rad: MCR220 to MCR320
pump: MCP350 to MCP355 w/petra top
Forgot to mention. Using the Apogee now, cpu temps aren't too bad, FX57 @ 3003 will be around 44c after a few hrs of prime95,,,,,room gets nice and toasty 28c
Thanks
tubing: (3/8 ID X 5/8 OD) to (1/2 ID X 3/4 OD)
rad: MCR220 to MCR320
pump: MCP350 to MCP355 w/petra top
Forgot to mention. Using the Apogee now, cpu temps aren't too bad, FX57 @ 3003 will be around 44c after a few hrs of prime95,,,,,room gets nice and toasty 28c
Thanks