- Joined
- Jan 5, 2007
- Location
- Houston, Texas
I'm getting the masterkleer 7/16" tubing from McMaster (5233K44) with the 3/32" thick walls. This makes the OD 5/8". If I'm using the constant-tension tube clamps, which OD clamps should I get? I'm thinking it's this one, 5324K44, which has 5/8" OD. Is this correct?
Anyone use these types? Good luck, bad luck?
Are worm-drive clamps that much better, easier? I don't mind them but I'm a bit concerned with the tightening of them. I don't want to over-tighten and cause a leak.
Anyone use these types? Good luck, bad luck?
Are worm-drive clamps that much better, easier? I don't mind them but I'm a bit concerned with the tightening of them. I don't want to over-tighten and cause a leak.