Jerky said:
hmmm, i've been messing around in the bios lately but i'm not sure i follow. lol!
it says user defined (or something like that) and i can change the dimm setting to auto, 133, or 166) but there are two "blued out" settings (i don't think i can change) that are above it.
i'll go look, write down what i see and then post it. brb.
here's what i came up with.
---------------------------
CPU SETUP:
cpu operating speed: 1700+ (133) - *or change to user defined
cpu, fsb, clock (mhz): 133/166 - *or change manualy from 100 -250
ratio: (fsb:agp: pci) 4:2:1 - * or can manualy change the fsb to 3,4,5
multiplier factor: x11 - *can change from 5 to over13
speed error control: disabled
enhance for benchmark: disabled
----------------------------
CPU PWR SUPPLY: ...i had these set a default, but i listed what it can do.
cpu power supply: 1.10 to 1.85v
i/o voltage: 3.50 to 3.65
ddr voltage: 2.55 to 2.85
__________________________
DRAM CLOCK DRIVE CONTROL:
(*BLUED OUT SETTINGS ARE ---> current fsb: 133
current dram frequency: 133
dram clock: - * can be changed to either spd - 133 - 166 (have set at 133) ...i'm running 2100 ram right now
dram timing: manual
dram cas latency 2
bank interleave: 4 bank
pre charge to active (trp): 2t
active to precharge (tras): 5t
active to cmd (trcd): 3t
ddr dqs input: auto (25) - *can be set to a bunch of different numbers each way by 1 up or 1 down, 1 - 100 or something. i didn't really check
ddr dqs output delay: auto (40) - *can be set to a bunch of different numbers each way by 1 up or 1 down, 1 - 100 or something. i didn't really check
--------------------------------------
dram access: 2t
dram queue depth: 4 level
dram command rate: 1t
dclk feedback delay: ps
those above can be changed also
now. what the hell do i do? lol!