- Joined
- Sep 18, 2002
- Location
- Austin, Texas
read this in another forum on how to get 200+ fsb without currupting files:
If you do NOT run a RAID setup and have your hard drive(s) plugged into the boards IDE Ports, go into the bios and set the Hard Drive controller from ULTRA DMA to Pio mode on both channels. On Next boot into Windows, go into system properties and then Device Manager....under IDE/ATAPI ATA controllers...set primary and secondary to Pio mode only. Reboot. After these changes you'll now be able to run your board to most any FSB without fear of corrupting your hard drives...
Does this work?
If you do NOT run a RAID setup and have your hard drive(s) plugged into the boards IDE Ports, go into the bios and set the Hard Drive controller from ULTRA DMA to Pio mode on both channels. On Next boot into Windows, go into system properties and then Device Manager....under IDE/ATAPI ATA controllers...set primary and secondary to Pio mode only. Reboot. After these changes you'll now be able to run your board to most any FSB without fear of corrupting your hard drives...
Does this work?