- Joined
- Apr 12, 2002
- Location
- Over here!
Hi I just got my new cpomputer with the following setup:
Motherboard: Abit TH7II
CPU: Pentium 4 1.6a
RAM: Samsung PC1066 - two 256MB sticks
Video: VisionTek Xsacy GeForce4 Ti4600
Sound: Soundblaster Audigy plat.
CD/DVD: Toshiba 16x48x
CDRW: Plextor 40x12x40x
Power Supply: 550Watt Enermax
Case: Antec SX1240
Misc: Standered floppy drive and NIC.
Cooling:
Dangerden Maze3 water block
Rio Submersible pump.
Heater core raidiator
And a nice little res I made myself
So far its working great, but now I'm ready to overclock it some to see if I got a good setup.
I just and a few questions, I went into the BIOS and saw something I didn't understand.
In the CPU setup menu, there are two selections at the bottom, they are;
"RDRAM bus frequency" which has the options of 300MHz, 400MHz, and auto, defult setting is auto.
The second thing is; "differential current", and the opitons for it are: 4x, 6x, 5x, and 7x, the defult setting is 6x.
What the heck are these settings for? Should I just leave them alone or what?
Also how do I set the PCI and RAM dividers for this board?
The awnser is probably right in front of me, but I wanted to be sure, before I fry my new system.
Thanks a bunch
Motherboard: Abit TH7II
CPU: Pentium 4 1.6a
RAM: Samsung PC1066 - two 256MB sticks
Video: VisionTek Xsacy GeForce4 Ti4600
Sound: Soundblaster Audigy plat.
CD/DVD: Toshiba 16x48x
CDRW: Plextor 40x12x40x
Power Supply: 550Watt Enermax
Case: Antec SX1240
Misc: Standered floppy drive and NIC.
Cooling:
Dangerden Maze3 water block
Rio Submersible pump.
Heater core raidiator
And a nice little res I made myself
So far its working great, but now I'm ready to overclock it some to see if I got a good setup.
I just and a few questions, I went into the BIOS and saw something I didn't understand.
In the CPU setup menu, there are two selections at the bottom, they are;
"RDRAM bus frequency" which has the options of 300MHz, 400MHz, and auto, defult setting is auto.
The second thing is; "differential current", and the opitons for it are: 4x, 6x, 5x, and 7x, the defult setting is 6x.
What the heck are these settings for? Should I just leave them alone or what?
Also how do I set the PCI and RAM dividers for this board?
The awnser is probably right in front of me, but I wanted to be sure, before I fry my new system.
Thanks a bunch