- Joined
- Feb 11, 2002
- Location
- U.P. Michigan
Here's another of my block concepts. The manufacture standpoint is faily simple and the hard work is done in the top pieces which would be lexan. Ok, on to the block itself. The inlet will constrict slightly then nozzle out over the thimble shape. Also the nozzle will be notched and over each notch there is a slash cut out in the raised ring which goes around the thimble shape. The sloping circle around the perimeter will store excess heat away from the core and be siphoned off by the knurled texture in its surface and the good water velocity that will hit it's surface. Water shall collect in a ring around the outside edge of the block and exit through multiple verticle holes into the mini resevoir at the very top of the block. The center piece over the core which initially will be a rounded thimble shape shall get hash cuts into it then spread apart to fill the channel opening in the lexan. Pressure should be well maintained throughout the block.
Edited for content
Edited for content
Last edited: