- Joined
- Dec 16, 2001
- Location
- VIctoria, BC, Canada
I was just thinking, would it be hard to make a rad myself? I need a small rad, one that is at the most 5"x5"x2", but preferably smaller. I remember someone here had a 4x4 rad custom made and it was only like $35. In order to make one, wouldn't I just have to take something like copper tubing and makeit run up and down and up and down and so on. I have access to metalworking equipment (ie: Pipe bending tools, etc). Also, are the fins important to the cooling process or will i get similar results with just bare tubing with air blowing over it.