- Joined
- Nov 30, 2002
- Location
- California
I'm signing up for metal shop when i go to college this summer. Trying not to completly copy other ideas, i made a design so that i may try it out in metal shop.
heres the bottom of the block and ...
heres the top.
I have the channels tamper a lot so that it jets through the center of the block. Instead of just horizontal lines across the center of the block, i went for squares.. i'll have to do this by hand with a carbon hobby knife though. I want to put an O-Ring for maintaince, clean small channels.
Basicly, the idea behind this design was to combine all my likes with retail blocks into one. Then again, i might have it all wrong, i'm a waterblock noob, btw the pictures are not to scale, i'll do that in autocad
heres the bottom of the block and ...
heres the top.
I have the channels tamper a lot so that it jets through the center of the block. Instead of just horizontal lines across the center of the block, i went for squares.. i'll have to do this by hand with a carbon hobby knife though. I want to put an O-Ring for maintaince, clean small channels.
Basicly, the idea behind this design was to combine all my likes with retail blocks into one. Then again, i might have it all wrong, i'm a waterblock noob, btw the pictures are not to scale, i'll do that in autocad