Results 1 to 2 of 2
  1. #1
    Member hkgonra's Avatar
    Join Date
    Aug 2001
    Location
    West TN.
    Posts
    1,681

    jumping the power on

    I am trying to work on my new nf7 on the table out of the case I have just the minimum hooked up to it. How do I get it to power on ? Can I just jump across the two pins for the power switch ? If so do I have to leave the jumper on ?
    "I am for doing good to the poor, but...I think the best way of doing good to the poor, is not making them easy in poverty, but leading or driving them out of it. I observed...that the more public provisions were made for the poor, the less they provided for themselves, and of course became poorer. And, on the contrary, the less was done for them, the more they did for themselves, and became richer."
    -- Benjamin Franklin

    My Heatware

  2. #2
    Member hkgonra's Avatar
    Join Date
    Aug 2001
    Location
    West TN.
    Posts
    1,681
    Nevermind .
    "I am for doing good to the poor, but...I think the best way of doing good to the poor, is not making them easy in poverty, but leading or driving them out of it. I observed...that the more public provisions were made for the poor, the less they provided for themselves, and of course became poorer. And, on the contrary, the less was done for them, the more they did for themselves, and became richer."
    -- Benjamin Franklin

    My Heatware

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •