- Joined
- Dec 18, 2003
- Location
- MI, USA
- Thread Starter
- #41
All pictures are at the bottom
Well, I finally got a couple more things done.
After looking over the pieces that were dry I noticed that a lot of them weren't very smooth, a lot of bumps. So I wet sanded most of them, a few turned out just fine. Here is the front panel that slides up and down on the case.
I got my shipment of fans in the mail. I never have used a 120mm fan before, and I have to say, they are a lot bigger than I thought. The hole I drilled was almost perfect. It is gonna look great in the case when it is mounted.
I dremeled out some holes for some switches I am going to install on the front panel. You won't see the mess I made of the holes, thankfully.
And I finally cut out the 80mm fan grill on the top-back of the case. I went with straight lines. What do you guys think of it? I'm wondering if I should leave hole as is or the normal circular.
Well, I finally got a couple more things done.
After looking over the pieces that were dry I noticed that a lot of them weren't very smooth, a lot of bumps. So I wet sanded most of them, a few turned out just fine. Here is the front panel that slides up and down on the case.
I got my shipment of fans in the mail. I never have used a 120mm fan before, and I have to say, they are a lot bigger than I thought. The hole I drilled was almost perfect. It is gonna look great in the case when it is mounted.
I dremeled out some holes for some switches I am going to install on the front panel. You won't see the mess I made of the holes, thankfully.
And I finally cut out the 80mm fan grill on the top-back of the case. I went with straight lines. What do you guys think of it? I'm wondering if I should leave hole as is or the normal circular.
Last edited: