- Joined
- Dec 30, 2007
- Location
- Peterborough
Hi, not been on here for a while but the last time you guys were stars in helping to overclock my Q6600 to 3.5ghz.
Anyway got hold of a Biostar TPower I45 mobo. Been trying to overclock it but the highest i can get is 2.6ghz!!!
When the overclock goes wrong, postcode E1 shows on the board and the only way to get it posting again is to clear the cmos via the jumper.
So has anyone got one of these and any settings that i need to change to get it to post.
Also cpu-z says the fsb:dram is set at 2.3 ratio, what do i need to change in the bios to get a 1:1 ratio as i think thats where the post is failing.
Smurf
Anyway got hold of a Biostar TPower I45 mobo. Been trying to overclock it but the highest i can get is 2.6ghz!!!
When the overclock goes wrong, postcode E1 shows on the board and the only way to get it posting again is to clear the cmos via the jumper.
So has anyone got one of these and any settings that i need to change to get it to post.
Also cpu-z says the fsb:dram is set at 2.3 ratio, what do i need to change in the bios to get a 1:1 ratio as i think thats where the post is failing.
Smurf