Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!
I like GPUs in series even though one GPU will run cooler than the other. If ran Parallel, they both will run almost exact temps but run warmer than in series.
Thank You GTX for the answer to my question. I'll take your advice as you have helped me a lot as I learn
Dumb question : if you are using 1/2 OD tubing, what size compressors/hose clamps should you be using?????
I messed up and ordered 1/2 OD hose clamps
Thank You For Your Time
In Reading And Replying
So you would match the ID size of the tube??????
Yes. The OD is just the thickness of the outer wall but the main size is the ID hence why you weren't able to tighten your clamp to the tubing.
Wait a minute.
ID means inside diameter
OD means outside diameter
If the ID is 3/8 inch and the OD is 1/2 inch (4/8) then the wall thickness is 1/8 inch. So the OD is not the thickness of the outer wall. Diameter and thickness are not synonymous.
View attachment 161521
I would think a 1/2 inch clamp would be appropriate.