I'm planning on custom sleeving for my PSU and a couple fans that came unsleeved. I'll sleeve all 3 wires on the fans with one sleeve first for practice then move to sleeving the PSU, each wire individually. I've read through a couple of the guides on the subjects but still on the fence about heatshrink and the heatgun.
I already bought enough Paracord 550 for my needs. I'm still trying to figure out what kind of heatshrink is best for individually sleeved wires? I know I don't want to use the heatshrink with adhesive, its a bad idea... but what about the shrink ratio? 2:1 or 3:1? Should I go pre-cut or cut them myself? Also, I'd like to get a heatgun for the shrinking. Anyone have some recs on a decently priced heatgun that gets the job done?
I already bought enough Paracord 550 for my needs. I'm still trying to figure out what kind of heatshrink is best for individually sleeved wires? I know I don't want to use the heatshrink with adhesive, its a bad idea... but what about the shrink ratio? 2:1 or 3:1? Should I go pre-cut or cut them myself? Also, I'd like to get a heatgun for the shrinking. Anyone have some recs on a decently priced heatgun that gets the job done?