- Joined
- Feb 8, 2017
- Location
- Minneapolis, MN
So after some reading and advice from a friend I was looking for something to put in my system for corrosion protection. Well I decided to go with water wetter. The thing is about 20-30 minutes after adding it to my system (only 3/4 cap full) i noticed these white little particles all in the water. I took a picture with the system off as I do not want to leave it going if this is going to cause more issues than it is worth.
Anyways I took a picture of the stuff in the res after it ran for an hour or so, but has been off all night while i decide if I want to flush and just go back to pure water. I have a silver kill coil which I have seen reports of causing corrosion on copper blocks etc.. so that is why I went with water wetter.
So is this crap floating around all in the water normal with water wetter? Should I be concerned and just flush my system now and go back with pure water?
Btw I appreciate all the help given on these forums. Since the "friend" that told me this stuff is great has no res and his tubing is solid red so he has no way of even knowing if this is happening inside his own loop.
Anyways I took a picture of the stuff in the res after it ran for an hour or so, but has been off all night while i decide if I want to flush and just go back to pure water. I have a silver kill coil which I have seen reports of causing corrosion on copper blocks etc.. so that is why I went with water wetter.
So is this crap floating around all in the water normal with water wetter? Should I be concerned and just flush my system now and go back with pure water?
Btw I appreciate all the help given on these forums. Since the "friend" that told me this stuff is great has no res and his tubing is solid red so he has no way of even knowing if this is happening inside his own loop.