since i cant read off the diode on this board, id like to ask you all your opinion on my temps so far. ive read from some that the board reads a bit high, a bit low, 3c away from diode, close to 10c.. ha.
@ ~1.9 Vcore (stock is 1.45Vcore), tornado 92mm @ ~3276RPM (max is ~4750) on SP97 (using ceramique)
idle: ~37-38
load: ~43-44
according to MBM5.6
using bios 22
im thinking of using my old 80-92mm adapter, and tie wrapping it to the holders on the heatsink, as i would like to funnel that air that comes off the sides in to the sink. that should drop the temps some (i hope, ha), so i can raise the core a bit.
what do you all think?
can someone give me the deviation from socket to diode on this board, if they can?
i have shutdown set to 65, so no worries about burning out the chip.. but i would still like to know where i stand.
thanks.
@ ~1.9 Vcore (stock is 1.45Vcore), tornado 92mm @ ~3276RPM (max is ~4750) on SP97 (using ceramique)
idle: ~37-38
load: ~43-44
according to MBM5.6
using bios 22
im thinking of using my old 80-92mm adapter, and tie wrapping it to the holders on the heatsink, as i would like to funnel that air that comes off the sides in to the sink. that should drop the temps some (i hope, ha), so i can raise the core a bit.
what do you all think?
can someone give me the deviation from socket to diode on this board, if they can?
i have shutdown set to 65, so no worries about burning out the chip.. but i would still like to know where i stand.
thanks.