- Joined
- Jan 9, 2003
- Location
- California
Ok, so i'm going to be upgrading to an 939 SLI setup, and i figured its time i got my feet wet and try a WC setup. I would like an internal setup in my Antec 1080 case, but I can't figure out a decent way to organize the WC.
I will be going SLI, but with a single 6800 ultra for at least some time, so here are the parts that i'm planning to purchase:
DD TDX cpu block
DD MAZE4 northbridge
DD MAZE4 gpu
BIX single rad
DD-D4 pump
10 ft. Tygon (IS THIS ENOUGH???)
DD T-line fillport (no res).
Now, where the heck am i suppose to fit all this stuff without cutting anything? Is that even possible? What would be a MINIMAL case cutting solution? Can i fit a dual 120 rad?
Also, when i do acquire a second 6800 in about 6 months, will a single pump/rad be able to handle all the heat?
I'm not looking for extreme OC'ing from my setup.
Oh, my planned PC parts:
A8N SLI
90mm 3500
evga 6800 ultra
1x raptor 74
1x 250 7200
single combo dvd/cdrw
1gig corsair (see sig)
Pictures would be GREATLY appreciated. Thank you.
I will be going SLI, but with a single 6800 ultra for at least some time, so here are the parts that i'm planning to purchase:
DD TDX cpu block
DD MAZE4 northbridge
DD MAZE4 gpu
BIX single rad
DD-D4 pump
10 ft. Tygon (IS THIS ENOUGH???)
DD T-line fillport (no res).
Now, where the heck am i suppose to fit all this stuff without cutting anything? Is that even possible? What would be a MINIMAL case cutting solution? Can i fit a dual 120 rad?
Also, when i do acquire a second 6800 in about 6 months, will a single pump/rad be able to handle all the heat?
I'm not looking for extreme OC'ing from my setup.
Oh, my planned PC parts:
A8N SLI
90mm 3500
evga 6800 ultra
1x raptor 74
1x 250 7200
single combo dvd/cdrw
1gig corsair (see sig)
Pictures would be GREATLY appreciated. Thank you.