Hey all!
Well, I finally got my 6002 in from SVC so I can start WC and overclocking my 64 3000+.
I did happen to have a couple of questions though:
1.When you guys upgrade do you usually swap out your tubing for fresh stuff that is refitted for the different mobo dimensions?
2.Is there a pump that is better/smaller than my eheim 1250? If I swap out my 1.2 id tubing(in #1), it is a pta to get it on the larger barb of the pump.
3.I currently have a chevette heatercore with a comair rotron 220mm fan (12v), the thing is big, wonder if I should switch to a single 120. Only WC my chip.
Thanks in advance for your thoughts!
Edit: I have been away from WC for ~2 years and I had no idea that people were going with 3/8" tubing and thinner RADs these days....
Well, I finally got my 6002 in from SVC so I can start WC and overclocking my 64 3000+.
I did happen to have a couple of questions though:
1.When you guys upgrade do you usually swap out your tubing for fresh stuff that is refitted for the different mobo dimensions?
2.Is there a pump that is better/smaller than my eheim 1250? If I swap out my 1.2 id tubing(in #1), it is a pta to get it on the larger barb of the pump.
3.I currently have a chevette heatercore with a comair rotron 220mm fan (12v), the thing is big, wonder if I should switch to a single 120. Only WC my chip.
Thanks in advance for your thoughts!
Edit: I have been away from WC for ~2 years and I had no idea that people were going with 3/8" tubing and thinner RADs these days....
Last edited: