- Joined
- Jan 24, 2002
I just built a rheostat baybus w/ 3 rheostats and installed an illuminated on/off switch.
The problem I have is that the switch looks like it's grounded. When I turn off the baybus, it shuts down the pc too. The rheostats work fine.
Sometimes when I shut down the pc using the shutdown screen,
it restarts by itself.
Without the ground connected to the switch there aren't any problems.
I would like to use the light on my switch, Any Suggestions?
The problem I have is that the switch looks like it's grounded. When I turn off the baybus, it shuts down the pc too. The rheostats work fine.
Sometimes when I shut down the pc using the shutdown screen,
it restarts by itself.
Without the ground connected to the switch there aren't any problems.
I would like to use the light on my switch, Any Suggestions?
You are breaking up the 12volt line, and if you put the ground to the switch it will probably not work. I split the 12volt coming from the molex with my spst.
