It's extremely hard to plug the 1/2" 1/8" tube into the 3/4" heatcore there with hot water for the tube..
my finger...
i plug the 5/8" but 3/4" is very difficult..
Hey, good job. Stretching hoses like that can be a pain. Also, you could just edit your first post...it shows you posted again 5 minutes after you posted the thread. What kind of pump do you have for your watercooling setup anyways?
I am glad you got them on. It was a difficult task for me as well. Since everyone here is always talking about optimizing flow rate, I couldn't see putting barbs on.
I even used the 5/8"OD plastic barbs for my ViaAqua 1300 pump. I thought for sure they would snap when I forcing the hose on, but they help together.
hey LPS. Glad you decided to this route! Next time, i mention this to other people. I will specifically say BOIL not heat... lolz sorry for not mentioning it
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.