- Joined
- May 1, 2003
- Location
- East of Cleveland, Oh
I bought this board and upgraded the bios, the bios filename is 8rda3a17.bin. Anyway, no problems, have a conservative overclock with a little extra voltage to the CPU and Ram...
However, recently, I turn on the computer and it hangs during post, before detecting the drives. Reset once or twice solves the problem.
Before this gets serious, any ideas? Power supply not giving a good signal? Not much stress on the power supply, really, an "old" Radeon 7500 and a single small HD (gotta fix that...)
This is not a disk boot problem, it hasn't got there yet. The last line I get is "nforce 2 ultra 400 support" (or "fsb 400 support" or similar).
My CPU regularly runs 42C with my fans turned down slow, but has been as high as 49 when I was playing games and forgot to turn the fans up. (The noise and lack of a fast video card is why I don't push it further, which it certainly can do!) How high should I allow the CPU to get (as shown by MBM)? I may finally get some Ceramique to help, too.
However, recently, I turn on the computer and it hangs during post, before detecting the drives. Reset once or twice solves the problem.
Before this gets serious, any ideas? Power supply not giving a good signal? Not much stress on the power supply, really, an "old" Radeon 7500 and a single small HD (gotta fix that...)
This is not a disk boot problem, it hasn't got there yet. The last line I get is "nforce 2 ultra 400 support" (or "fsb 400 support" or similar).
My CPU regularly runs 42C with my fans turned down slow, but has been as high as 49 when I was playing games and forgot to turn the fans up. (The noise and lack of a fast video card is why I don't push it further, which it certainly can do!) How high should I allow the CPU to get (as shown by MBM)? I may finally get some Ceramique to help, too.