I thought this would be helpfull for everyone.
To mount a fan or shroud to a heater core use Transmission cooler mounting hardware. Part#226201. This is made of nylon and is used to mount a Tranny cooler through radiator fins.
http://img29.photobucket.com/albums/v87/diehrd/P3060859.jpg
You simply thread them through no damage at all doing this.
Here is a blurry pic, but it shows the end that you slide on Zip tie style.There are also 4 foam pads as well.
http://img29.photobucket.com/albums/v87/diehrd/P3060855.jpg
The rad and this kit where 23.99 and the rad will accept 2x120mm fans easily.It is 11.5 X 5.5/8 and 2 inches deep. The inlet and out let tubes have approx 1.5 inches of perfectly straight cooper tubing before making a turn to the left.More then enough to cut and mod easily..
To mount a fan or shroud to a heater core use Transmission cooler mounting hardware. Part#226201. This is made of nylon and is used to mount a Tranny cooler through radiator fins.
http://img29.photobucket.com/albums/v87/diehrd/P3060859.jpg
You simply thread them through no damage at all doing this.
Here is a blurry pic, but it shows the end that you slide on Zip tie style.There are also 4 foam pads as well.
http://img29.photobucket.com/albums/v87/diehrd/P3060855.jpg
The rad and this kit where 23.99 and the rad will accept 2x120mm fans easily.It is 11.5 X 5.5/8 and 2 inches deep. The inlet and out let tubes have approx 1.5 inches of perfectly straight cooper tubing before making a turn to the left.More then enough to cut and mod easily..