Ok I've been tinkering around with o/c on this. I'm new so be patient with me. Here is a link to a thread that I have gotten some info in so far and also provides some of the info anyone responding may want to know.
http://www.ocforums.com/showthread.php?s=&threadid=293021
With that said, here is my question(s) with a little bit of info that I have gathered that will hopefully give anyone an idea of what I have gathered so far. Ok from reading the forums I have discovered that the agp and pci can't be locked via the bios unless there is a post I missed. So I was like ok I should be able to up the fsb to 166 and with the 5:2:1 ratio that will keep the agp and pci at their normal clock. I am wondering what the effects are of the inbetween does the agp and pci run at lower than normal clock or does the mobo compensate or something to keep the clocks at 66 and 33. On the oposite end what about o/c of the agp and pci due to keeping at the 4:2:1 ratio? Also am wondering about the ram. As in my experimenting listed in the other thread it was stated that its possible the ram might be holding back o/c more. Would o/c the ram help in obtaining a higher o/c? And finally what do I want to take into consideration in changing the fsb and possible o/c of the agp, pci, and ram?
Hopefully this isn't too much for one post. But I am slowly beggining to understand some of this o/c stuff.
Thanks for any help that anyone can provide and if nothing else some helpful pointers.
Abit KD7-RAID | 1800+ with volcano 12
crucial PC2100 512MB x2 (1024MB)
intake 3 Evercool 80mm (3000rpm) aluminum
out side 1 Evercool 120mm (2200rpm) aluminum
PSU Allied 400W
Leadtek GeForce4 MX440 AGP8x 64MB
2x 120GB and 2x 250GB WD 7200 8MB
http://www.ocforums.com/showthread.php?s=&threadid=293021
With that said, here is my question(s) with a little bit of info that I have gathered that will hopefully give anyone an idea of what I have gathered so far. Ok from reading the forums I have discovered that the agp and pci can't be locked via the bios unless there is a post I missed. So I was like ok I should be able to up the fsb to 166 and with the 5:2:1 ratio that will keep the agp and pci at their normal clock. I am wondering what the effects are of the inbetween does the agp and pci run at lower than normal clock or does the mobo compensate or something to keep the clocks at 66 and 33. On the oposite end what about o/c of the agp and pci due to keeping at the 4:2:1 ratio? Also am wondering about the ram. As in my experimenting listed in the other thread it was stated that its possible the ram might be holding back o/c more. Would o/c the ram help in obtaining a higher o/c? And finally what do I want to take into consideration in changing the fsb and possible o/c of the agp, pci, and ram?
Hopefully this isn't too much for one post. But I am slowly beggining to understand some of this o/c stuff.
Thanks for any help that anyone can provide and if nothing else some helpful pointers.
Abit KD7-RAID | 1800+ with volcano 12
crucial PC2100 512MB x2 (1024MB)
intake 3 Evercool 80mm (3000rpm) aluminum
out side 1 Evercool 120mm (2200rpm) aluminum
PSU Allied 400W
Leadtek GeForce4 MX440 AGP8x 64MB
2x 120GB and 2x 250GB WD 7200 8MB