- Joined
- Dec 11, 2003
- Location
- Northeast Ohio
thinking of designing an external watercooling setup according to this design. going to mount this on top of my current case modding a new lexan window mod to mount this external case onto it with two holes for the tygon tubing. going to construct the case with 3/4" alluminum angle for the frame, which I will rivet together with a 'blind pop-riviter with 1/8" thick lexan to for the sides. planning on using weather striping between the alluminum and the lexan to make the box air tight. Going to purchase a Swiftech MCP-600 12 volt pump, Danger Den TDX (cpu block), Maze4 Den waterblock for gpu for graphics card, 1/2 fittings, Chevette heatercore, 10 feet tygon tubing, and a Danger Den Dual 5 1/4 bay Res. will paint the alluminum angle black to match my case. Any advice and suggestions would greatly be appreciated.