- Joined
- Aug 3, 2003
After a week of priming, i've gotten what i will consider my accepted load and idle cpu temps.
Note, my rig is a dually, and both WBs are on, but only one cpu atm.
Room temp: 28*C
Case temp: 35*C
CPU temp (idle): 42*C
CPU temp (load): 45*C
this is with my 2 rad fans at the lowest speed.
I am not too pleased with these results, seeing that my cpu is underclocked to ~1.8gHz. The WB is a Dtek TC-4 rev1, the pump is an MCP650, and the rad is a 240x120mm heatercore. All case fans are blowing out to compensate for the large influx at the radiator (i want roughly neurtal case pressure to minimize dust and cat fur collection).
The block is mounted with AS5, and the blocks are both well lapped.
Any tips on lowering these temps? or is this the best i will do in Florida in the summer?
Thanks,
David
Note, my rig is a dually, and both WBs are on, but only one cpu atm.
Room temp: 28*C
Case temp: 35*C
CPU temp (idle): 42*C
CPU temp (load): 45*C
this is with my 2 rad fans at the lowest speed.
I am not too pleased with these results, seeing that my cpu is underclocked to ~1.8gHz. The WB is a Dtek TC-4 rev1, the pump is an MCP650, and the rad is a 240x120mm heatercore. All case fans are blowing out to compensate for the large influx at the radiator (i want roughly neurtal case pressure to minimize dust and cat fur collection).
The block is mounted with AS5, and the blocks are both well lapped.
Any tips on lowering these temps? or is this the best i will do in Florida in the summer?
Thanks,
David