Hey all im in the process of building a wcooling system. Im getting the parts mainly from these classies as im not rele in a big rush and im a bit short on cash. I want you opinion on the folowing setup. I will be using it on the pc in my sig.
Already got:
Swiftech Storm
240mm x 120mm Heater core
Waterchill Nb block - not sure if ill use it
Misc 120mm fans i could use....or i could buy come more if needed
May be getting soon:
Eheim 1250
Need to get:
T-line - cheaper than res.
1/2" tubing
1/2" barbs for nb block.
What do u guys think???
A few Qs
- how much will the quality of the tubing effect the temps? basically can i get the cheapest 1/2" tubing and not worry
- should i use the nb block or will it hinder temps too much
- have i forgotten anything?
Edit: some more Qs
- is the pump sufficient?
- the cpu and nb blocks are copper but the heater core is alu...iv herd i can minimize corrosion by using a high proportion of anti-freze....is this correct?
Thanks in advance
Sam
Already got:
Swiftech Storm
240mm x 120mm Heater core
Waterchill Nb block - not sure if ill use it
Misc 120mm fans i could use....or i could buy come more if needed
May be getting soon:
Eheim 1250
Need to get:
T-line - cheaper than res.
1/2" tubing
1/2" barbs for nb block.
What do u guys think???
A few Qs
- how much will the quality of the tubing effect the temps? basically can i get the cheapest 1/2" tubing and not worry
- should i use the nb block or will it hinder temps too much
- have i forgotten anything?
Edit: some more Qs
- is the pump sufficient?
- the cpu and nb blocks are copper but the heater core is alu...iv herd i can minimize corrosion by using a high proportion of anti-freze....is this correct?
Thanks in advance
Sam
Last edited: