Temps seem a little high...please help

Right now I have an unlidded Q6600 B3 stepping under water using the following items:

Apogee GT
MCP655
3x120mm single pass radiator (DangerDen)
dual 3 1/2" rez (have a micro rez but haven't installed it yet)

I have applied 1.4875 volts via the BIOS but every program I have (everest, speedfan, ASUS AI, CPUID) reads the voltage at 1.35 to the chip. I don't know if ASUS is wrong or these programs are wrong...don't have a multimeter on me.

I am currently at 3.33Ghz as you can see from CPUID and Everest in the picture below. I think my temps are a little high for this setup and cannot for the life of me figure out why.

Most obvious possibility is bad contact between block and CPU. Remove block and check there is an even, very thin spread of paste.

What fans are on the rad? How much airflow?

Unfortunately I only have 2 120mm fans on it at the moment. They are silverstone FM121 running at 100%. I tested with a third and it didn't help temps at all...so I took it off.

Here is a link to my silverstone fans LINK

what is the temp of your water?

I will have to go purchase a thermometer and put it in later today.

well it is below 88F as it doesn't register on my thermometer which really upsets me that i purchased a thermometer that doesn't work with how cool the water is.

If your water temp is below 88°F then I'd say you have a mounting problem.

Just out of curiosity what TIM are you using? I doubt that's the problem, I'm just curious ...

Unfortunately I could not find my AS5 so I am using Ceramique.

I readjusted the mounting and have had no luck dropping the temps at all.