- Joined
- Aug 3, 2008
Hey Gang,
I just screwed my Asus P5Q-E into my Antec 1200. My question is, do I need to use these little red washers that came with my case? If so, do they go above the standoffs and behind the mobo, between the mobo and my screw, or both?
I'm using the screws with wide, flat faces that cover the little nubs around screw hole...is there a different type of screw I should be using? I made sure not to use the ribbed ones...only smooth ones.
Any input would be greatly appreciated. I haven't hit her with power yet....so there is still time to undo any mistakes!
Thanks again for any input,
Rabid
I just screwed my Asus P5Q-E into my Antec 1200. My question is, do I need to use these little red washers that came with my case? If so, do they go above the standoffs and behind the mobo, between the mobo and my screw, or both?
I'm using the screws with wide, flat faces that cover the little nubs around screw hole...is there a different type of screw I should be using? I made sure not to use the ribbed ones...only smooth ones.
Any input would be greatly appreciated. I haven't hit her with power yet....so there is still time to undo any mistakes!
Thanks again for any input,
Rabid