- Joined
- Sep 10, 2009
- Location
- NW Indiana
Good day everyone.
When running at default speeds my idle temp is 38, my load temp is 68 on my 920 DO (after 5 hours of prime95).
When running at OC speeds my idle temp is 70, and I am afraid to go any further. What do you think is wrong with this OC?
-In both cases H2O temp is 32*C (current ambient is 21*C)
Temps are monitored via HWmonitor.
CPU Voltage: 1.35
CPU PLL Voltage: 1.96
QPI/DRAM Core: 1.35
DRAM bus voltage: 1.66
CPU Differential Amplitue: 800 mv
DRAM frequency: DDR3-1603
BCLK: 200
CPU ratio; 20 (same temperature results at 19 or 18)
C1E support: Disabled
C-STATE: enabled
Turbo Mode: Disabled
SpeedStep: Disabled
Cooling: fesser 480, 665 set to 4.5, 1/2 ID, Apogee GTZ SE, Bitspower NB/SB block, DangerDen full coverage 285 V2 block... currently fans are running at 100%, but I will decrease this soon.
When running at default speeds my idle temp is 38, my load temp is 68 on my 920 DO (after 5 hours of prime95).
When running at OC speeds my idle temp is 70, and I am afraid to go any further. What do you think is wrong with this OC?
-In both cases H2O temp is 32*C (current ambient is 21*C)
Temps are monitored via HWmonitor.
CPU Voltage: 1.35
CPU PLL Voltage: 1.96
QPI/DRAM Core: 1.35
DRAM bus voltage: 1.66
CPU Differential Amplitue: 800 mv
DRAM frequency: DDR3-1603
BCLK: 200
CPU ratio; 20 (same temperature results at 19 or 18)
C1E support: Disabled
C-STATE: enabled
Turbo Mode: Disabled
SpeedStep: Disabled
Cooling: fesser 480, 665 set to 4.5, 1/2 ID, Apogee GTZ SE, Bitspower NB/SB block, DangerDen full coverage 285 V2 block... currently fans are running at 100%, but I will decrease this soon.