Here is my current setup, look at how the T-Line and the pump connect.
Since I have a little bit of money now I was thinking that I could grab a new threaded front to my Iwaki MD-20Z (http://www.customaquatic.com/customaquatic/brandcategory.asp?brandID=IK&catID=wp&offset=15 Part No:WP-IKMD0313 I believe this is the right front i could be wrong though??? Better place to get it???) and then attach the T-Line directly to the pump. For a cleaner look and perhaps better performance.
The T-Line threads are 3/4" FIP (female) and the pumps threads will be 3/4" NPT (male). So my question is will the threads be compatible???
Will 3/4" FIP fit on 3/4" NPT?
Since I have a little bit of money now I was thinking that I could grab a new threaded front to my Iwaki MD-20Z (http://www.customaquatic.com/customaquatic/brandcategory.asp?brandID=IK&catID=wp&offset=15 Part No:WP-IKMD0313 I believe this is the right front i could be wrong though??? Better place to get it???) and then attach the T-Line directly to the pump. For a cleaner look and perhaps better performance.
The T-Line threads are 3/4" FIP (female) and the pumps threads will be 3/4" NPT (male). So my question is will the threads be compatible???
Will 3/4" FIP fit on 3/4" NPT?