Heatercores don't really come barbed, you have to cut the existing pipes down and jbweld/solder the hose barbs you intend attach. You can plug the existing hole and make new ones on the back side of the tanks as well.
The fittings that come on chevette heatercores have a sinble barb on each. the smaller fitting is 1/2"od, and the larger one is 5/8"i think. You can stretch some 1/2"id tubing over them pretty easily, without soldering, or jbwelding. It is alot easier, then just add a hose clam and it will not come off!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.