- Joined
- Oct 19, 2001
I recently upgraded to a CeleronII 1.1 ghz flip chip. I am only able to overclock this chip to 1157mhz. All higher speeds lock up once I get to Windows ME (wallpaper appears, with mouse pointer in center-- then locks up). I tried Safe Mode and am able to boot at 1320mhz, sometimes at 1364. I tried using CPUFsb (software), hoping that I could change the bus speed after boot up was complete, but it only allows me to go down in speed. If I try to go up, the same lockup occurs. Any ideas about how to push the clock speed a little higher than 1157mhz under WinMe without lockups? I have bumped voltage as high as 2.05 with no improvement. I was running a CeleronII 633@999mhz previously, so this gives me about a 16% increase, but I was hoping for more.
About my system... ASUS P3V4X with Iwill slocket. Corsair pc133 RAM. Voodoo5 5500 graphics (overlclocked to 183), Aureal SQ 2500 sound, Allied Tele AT-2400 PCI Ethernet, generic 56k ISA modem, GlobalWin FOP32 CPU cooling. Two case fans. Also, 32x cd-rom, HP tape backup, and the usual floppy drives.
Any help would be appreciated.
About my system... ASUS P3V4X with Iwill slocket. Corsair pc133 RAM. Voodoo5 5500 graphics (overlclocked to 183), Aureal SQ 2500 sound, Allied Tele AT-2400 PCI Ethernet, generic 56k ISA modem, GlobalWin FOP32 CPU cooling. Two case fans. Also, 32x cd-rom, HP tape backup, and the usual floppy drives.
Any help would be appreciated.