Hi,
my 2nd system is limited to a minimum voltage of 1.80Volt.
(I'm familiar with the P2B limitations with running coppermines of 1.75V, multipliers 11 and 12, and such..)
I would like to be able to get 1.6V or so from it.
Can this be done?
The vidpins tell the motherboard what voltage it should supply (let's say 1.8V in this case) but where does that 1.8Volt go into the chip? What pins..
If this is a few pins can I put resistors on those lines to lower the supplied Voltage? How much Ohm value, what type of resistors to get from 1.8 to 1.6V?
Links / info appreciated.
tia.
my 2nd system is limited to a minimum voltage of 1.80Volt.
(I'm familiar with the P2B limitations with running coppermines of 1.75V, multipliers 11 and 12, and such..)
I would like to be able to get 1.6V or so from it.
Can this be done?
The vidpins tell the motherboard what voltage it should supply (let's say 1.8V in this case) but where does that 1.8Volt go into the chip? What pins..
If this is a few pins can I put resistors on those lines to lower the supplied Voltage? How much Ohm value, what type of resistors to get from 1.8 to 1.6V?
Links / info appreciated.
tia.