emorris1911
New Member
- Joined
- Dec 27, 2012
To anyone out there with a q6600 on a ga-ep45-ud3p mobo im looking for stable settings for this combo. Ive had no luck on my own and am new to overclocking and this site. Any help would be appreiated.
-
Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!
OCing q6600 & ep45-ud3p
- Thread starter emorris1911
- Start date
- Joined
- Dec 17, 2000
- Location
- Portland, OR
What's the EXACT model of RAM installed, including the quantity, rated timings and voltage? Also note the stepping / revision of your chip (found w/ CPU-Z open to the CPU tab), and use Core Temp to identify the VID.
OP
emorris1911
New Member
- Joined
- Dec 27, 2012
- Thread Starter
- #3
The memory is Kingston hyperx 2x2gb, 5,5,5,15,@ 1.8v, stepping is b, revision is G0, and the vid is 1.408....i hope this helps and thank you for answering.
- Joined
- Dec 17, 2000
- Location
- Portland, OR
What frequency are the modules rated at? Assuming they're DDR2-800, give these settings a try for 3.2GHz...
Code:
CPU Clock Ratio: 8x
CPU Host Clock Control: Enabled
CPU Host Frequency (Mhz): 400
PCI Express Frequency (Mhz): 100
C.I.A.2: Disabled
Performance Enhance: Standard
Extreme Memory Profile (X.M.P.): Auto
(G)MCH Frequency Latch: 400MHz
System Memory Multiplier: 2.00D
Memory Frequency (Mhz): 800
DRAM Timing Selectable: (SPD) [Manual]
CAS Latency Time: 5
tRCD: 5
tRP: 5
tRAS: 15
CPU Load Line Calibration: Enabled
CPU Vcore: 1.325
DRAM Voltage: 1.800
(All other voltages on Auto)
Limit CPUID Max. to 3: Disabled
No-Execute Memory Protect: Enabled
CPU Enhanced Halt (C1E): Disabled
C2/C2E State Support: Disabled
x C4/C4E State Support: Disabled
CPU Thermal Monitor 2(TM2): Enabled
CPU EIST Function: Disabled
Last edited:
OP
emorris1911
New Member
- Joined
- Dec 27, 2012
- Thread Starter
- #5
2.0v
